Skip to content
CYT Hydraulic B2B Hydraulic Fittings Manufacturer and Supplier

Article ยท October 19, 2026

BSP Parallel and BSP Tapered: Same Nominal Size, Different Thread

A parallel thread and a tapered thread can share a nominal size and still not be the same part. Here is how to tell them apart.

BSP threads appear in two forms, and the nominal size alone does not identify which one you have. A parallel thread and a tapered thread with the same name are not the same interface.

Where the difference shows

Measure the outside diameter at two points along the thread. On a parallel thread the two readings match. On a tapered thread the diameter grows toward the end of the fitting.

Caliper measuring thread diameter at two points along a fitting
Photo brief 400 × 300 — diameter measured at two points along the thread.

How each one seals

A parallel thread commonly seals on a bonded washer or an O-ring against the face of the port. A tapered thread seals along the thread contact itself, commonly assembled with a sealant selected for the medium and the pressure of the application.

What to measure

  • Outside diameter at two points along the thread.
  • Pitch: threads per inch, or millimetres between crests.
  • Seat condition: flat face, washer groove, or threads only.

If the measurements suggest a tapered thread, record the taper rather than assuming the nominal size. We quote against the specification you send.

All articles

A question this note does not answer

Send the part number, the thread or a photograph. Identification comes before price, and both come back in the same reply.