Skip to content
CYT Hydraulic B2B Hydraulic Fittings Manufacturer and Supplier

Article · October 19, 2026

Measuring Hydraulic Hose Assembly Length: Which Two Points Count

Assemblies are quoted to the fitting end or to the seating face. A length without its convention sits wrong on the machine.

Hose assembly length is measured, not guessed — and the measuring convention has to match how the assembly is built. A length taken between the wrong two points produces a hose that looks right on paper and sits wrong on the machine.

The two points that define a length

Assemblies are quoted either to the end of the fitting or to the seating face. Both conventions exist; they differ by roughly the length of the fitting ends, which is enough to matter on a tight run.

Tape measure run along a laid-out hose between two fitting ends
Photo brief 592 × 368 — tape run straight along the laid-out assembly.

How to measure

  1. Lay the assembly out straight, without tension.
  2. Run the tape along the hose, not along a chord across a bend.
  3. Record which convention the number follows.

What to include with the order line

  • Length, with the measuring convention stated.
  • End fitting at each end, identified by thread and seat.
  • Whether the run is fixed or moves in service — a moving run needs clearance, not just length.

State the convention with the number and the assembly can be built and checked against the same reference points.

All articles

A question this note does not answer

Send the part number, the thread or a photograph. Identification comes before price, and both come back in the same reply.