Skip to content
CYT Hydraulic B2B Hydraulic Fittings Manufacturer and Supplier

Article · October 19, 2026

Checking a Leaking Hydraulic Fitting: Surface, Assembly or Specification

Most leaks at a fitting come from the sealing surface, the assembly, or the specification. A fixed check order separates them.

A leak at a hydraulic fitting is a symptom, not a diagnosis. Before any part is replaced, the joint is worth checking in a fixed order — most leaks at a fitting come from the sealing surface, the assembly, or the specification, and each has a different fix.

Check the sealing surface first

Look at the seat before touching anything else. A scratched cone, a nicked O-ring groove or a flattened washer face will leak regardless of how tightly the joint is assembled.

Then the assembly

  • Was the joint tightened to the torque its specification calls for?
  • Was a seal used once and reused?
  • Is the O-ring seated in its groove, or pinched under the face?

Then the specification

If the surface and the assembly both check out, the interface itself is the question: two threads with the same nominal name can differ in taper or seat, and a joint that almost fits can pass a bench test and leak under pressure.

Fitting seat inspected under a work light
Photo brief 400 × 300 — seat inspected under a work light before disassembly.

Record what the seat looks like before the joint is opened. Once cleaned and reassembled, the evidence that identified the problem is gone.

All articles

A question this note does not answer

Send the part number, the thread or a photograph. Identification comes before price, and both come back in the same reply.