Skip to content
CYT Hydraulic B2B Hydraulic Fittings Manufacturer and Supplier

Article · October 19, 2026

How to Identify Hydraulic Fitting Threads

A quick method for telling JIC, BSP, NPT and ORFS threads apart before you send an inquiry.

Sending an inquiry with the wrong thread notation is one of the most common causes of a delayed quote. Before you write to us, a few minutes with a caliper and a camera is usually enough to identify what you have. This article walks through the measurements that matter and the four thread families we see most often.

Start with what you can measure

Four numbers describe almost every hydraulic fitting thread. None of them requires special equipment — a caliper, a thread gauge (or a ruler for a quick pitch check), and good light are enough.

  • Thread diameter — measure across the peaks of the thread, not the roots.
  • Pitch — threads per inch (TPI) on imperial threads, millimetres between crests on metric threads.
  • Parallel or tapered — a tapered thread grows visibly in diameter along its length; a parallel thread does not.
  • Seat type — the sealing surface at the opening: a cone, a flat face with an O-ring, or a bonded washer face.
Close-up of a fitting thread being measured with a caliper
Photo brief 592 × 368 — thread diameter measured across the peaks.

The four families we see most often

JIC (SAE J514)

A 37° flare seat on a parallel UNF thread. The sealing surface is the cone at the opening; the threads hold the joint together but do not seal it.

BSP (BS 5200 / ISO 1179 family)

Comes in two forms. BSPP (G) is parallel and seals on a bonded washer or O-ring against the face. BSPT (R or Rc) is tapered and seals on the threads themselves. A G thread and an R thread with the same nominal size are not the same part.

NPT / NPTF (ASME B1.20.1)

A 60° tapered thread common on North American equipment. Diameter changes along the length of the thread, which is the quickest visual cue.

ORFS (SAE J1453)

A flat face with an O-ring in a groove, on a straight thread. The O-ring does the sealing; the flat face is unmistakable once you know to look for the groove.

Three fitting ends side by side showing different seat types
Photo brief 400 × 300 — seat types side by side: cone, flat face with O-ring, bonded-washer face.

What to send with your inquiry

A short, complete description saves a round of emails. We quote against the specification you provide, so it pays to be precise about the interface rather than the application it came from.

  1. One photo of the thread, one photo of the seat.
  2. Measured diameter and pitch, with units.
  3. The seat type you identified above.
  4. Quantity, and any surface or packing requirements confirmed for the job.

Measure the thread and the seat, not the part number stamped on an old fitting — stampings vary between manufacturers and do not always describe the interface.

If anything is ambiguous after measuring, send the photos and numbers as they are. We would rather check a measurement with you than quote against a guess.

Fitting laid out with caliper, thread gauge and notebook
Photo brief 1248 × 560 — the full identification kit: caliper, thread gauge, camera.

All articles

A question this note does not answer

Send the part number, the thread or a photograph. Identification comes before price, and both come back in the same reply.