Skip to content
CYT Hydraulic B2B Hydraulic Fittings Manufacturer and Supplier

Article ยท October 19, 2026

How to Read a Hydraulic Hose Specification

A hose line is more than a diameter and a length. These are the fields that decide which hose is being asked for.

When a hose assembly is specified, each number on the request line describes a different decision. Reading them together avoids ordering a hose that fits the space but not the job.

The fields that matter

  • Inside diameter, often given as a dash size as well as in millimetres or inches.
  • Working pressure, stated in the specification rather than assumed from the diameter.
  • Construction or grade, the designation used for the hose family.
  • Length, measured the way the assembly is recorded.
  • End fittings, one for each end, identified by thread and seat.

Dash size is not the whole story

A dash size describes the inside diameter only. Two hoses with the same dash size can differ in pressure rating and construction, so the remaining fields have to travel with it on the order line.

Hose label close-up with the specification fields visible
Photo brief 592 × 368 — hose label, fields visible for transcription.

What to send with the inquiry

  1. The hose designation or grade.
  2. Inside diameter and working pressure.
  3. Assembly length and the fitting at each end.
  4. Application notes where the environment matters.

All articles

A question this note does not answer

Send the part number, the thread or a photograph. Identification comes before price, and both come back in the same reply.