Skip to content
CYT Hydraulic B2B Hydraulic Fittings Manufacturer and Supplier

Article ยท October 19, 2026

JIC vs ORFS: How to Tell Two Sealing Styles Apart

Two common hydraulic sealing styles look alike from the outside. The seat tells you which one you have.

Both JIC and ORFS fittings appear on mobile and industrial equipment, and both can look similar at a glance. Identifying which one you have takes a minute, and it starts at the opening of the fitting rather than at the nut.

Look at the seat first

A JIC fitting seals on a 37° machined cone at the end of the tube or fitting. There is no elastomer at the joint — the metal cone is the sealing surface.

An ORFS fitting seals on a flat face with an O-ring sitting in a groove. The flat surface and the groove are the identifying features.

Two fitting ends side by side, one with a cone seat and one with a flat face
Photo brief 592 × 368 — cone seat and flat face with O-ring, side by side.

Two details that confirm it

  • The O-ring groove. Present on ORFS, absent on JIC.
  • The sealing surface. A polished cone points to JIC; a flat machined face points to ORFS.

What to record before ordering

  1. Seat type: cone or flat face with O-ring.
  2. Thread diameter and pitch.
  3. Whether the fitting is straight or an elbow, and the angle.
  4. The O-ring size, if the groove is visible and measurable.

Send the photographs with your inquiry and we will confirm the interface against the specification you provide.

All articles

A question this note does not answer

Send the part number, the thread or a photograph. Identification comes before price, and both come back in the same reply.