Skip to content
CYT Hydraulic B2B Hydraulic Fittings Manufacturer and Supplier

Article · October 19, 2026

Measuring O-Rings on Hydraulic Fittings: Two Numbers That Matter

An O-ring close enough to assemble will not necessarily stay sealed under pressure. Measure inside diameter and cord thickness without stretching the ring.

O-rings do the sealing on several hydraulic interfaces, and the wrong size is one of the easier mistakes to make — an O-ring that is close enough to assemble will not stay sealed under pressure. Measuring one correctly takes calipers and a consistent method.

What to measure

  • Inside diameter, measured across the groove the ring sits in where the ring itself is missing.
  • Cross-section (cord thickness), taken at one point and not averaged across wear.
O-ring measured with digital calipers on a neutral surface
Photo brief 592 × 368 — cross-section measured at a single point.

Measurement habits that keep the numbers usable

  1. Measure at room temperature, with the ring off the fitting.
  2. Do not stretch the ring while measuring — a stretched reading reads large.
  3. Record both numbers with units, and note the groove they came from.

Material is a separate question

Size is only half of the identification. The medium, the temperature range and the pressure of the application decide the elastomer, and that choice belongs with the specification rather than with the caliper reading.

Send the two measured numbers with your inquiry and we will check them against the interface you describe.

All articles

A question this note does not answer

Send the part number, the thread or a photograph. Identification comes before price, and both come back in the same reply.