Article · October 19, 2026
Metric or Inch: A Practical Method for Sorting Unknown Threads
Sorting an unknown thread into metric or inch first makes every later check faster. Two measurements decide it.
Unknown fittings sort into two families before anything else: metric and inch. Separating them first makes every later check — pitch, seat, standard — faster and less confusing.
The two quick tests
- Pitch. If threads-per-inch describes the spacing cleanly, the thread is imperial. If the spacing is a round number of millimetres, it is metric.
- Diameter. A caliper reading near a round millimetre figure suggests metric; a reading that only makes sense in inches suggests imperial.
What often goes wrong
Nominal names are the usual trap. A size written on an old drawing or spoken from memory can sit in either system, and guessing from the name costs more time than measuring.
Record before you sort
- Measured diameter, with the unit.
- Pitch or TPI, whichever applies.
- Parallel or tapered.
With those three lines, a thread can be placed in its family without reference to where the fitting came from.
A question this note does not answer
Send the part number, the thread or a photograph. Identification comes before price, and both come back in the same reply.